Chair: Christos Dimitrakopoulos
Since 2004, the first exfoliation of graphene, many researchers have been interested in two dimensional (2D) materials because of their intriguing electrical and optical properties and extremely low thickness. Black phosphorus, which is a new member of 2D materials, has shown unique properties compared with graphene. It has a tunable, thickness-dependent bandgap from 0.3 eV (bulk) to 2.0 eV (monolayer), and electrical mobility of 1,000 cm2/Vs. It also shows intrinsic anisotropy characteristics for thermal and electrical conductivity, and mechanical strength.
Two-terminal memory devices were fabricated by spray coating liquid-exfoliated black phosphorus ink to form the active device layer on a heavily doped Si substrate (bottom electrode), followed by spray coating of a liquid-exfoliated graphene layer through a stencil mask (top electrode). Memory devices fabricated with black phosphorus inks prepared by 3,000 rpm maximum centrifugation for separating the thin exfoliated flakes show volatile resistive memory device characteristics, specifically static random access memory (SRAM), and bipolar resistive switching characteristics. It shows a high on/off current ratio and good retention stability over 104 s. The device also showed multilevel data storage performance under different compliance currents, from 10-2 to 10-5 A. Importantly, a non-volatile memory device was also fabricated, using ink that comprised thinner, on average, black phosphorus flakes with a narrower thickness distribution than the ink used in the above-described devices. Such ink was prepared by a 10,000 rpm maximum centrifugation step for separating the thin exfoliated flakes. The non-volatile memory device showed good write/erase operation during 100 endurance cycles, like flash memory, and an on/off current ratio of around 1.9 x 103 at 0.5 V.
We synthesized graphene by using the chemical vapor deposition (CVD) technique on copper foil. We also fabricated interlayer bonded graphene bi- and multi-layers by using hydrogen plasma and annealing under argon conditions at 400 °C. The prepared graphene was transferred on a TEM grid with a Formvar supporting layer to prepare the suspended graphene film. We used AFM to measure the mechanical and tribology characteristics of such graphene. As a result, the calculated Young’s modulus was 1.003 ± 0.179, 0.918 ± 0.097, and 0.827 ± 0.124 TPa for single-, bi-, and interlayer bonded bi-layer graphene. The interlayer bonded bi-layer graphene shows a smaller deviation from the linear elastic model than single- and bi-layer graphene because interlayer bonding prevents the slippage between the layers during the indentation test. We calculated interfacial shear strength and contact radius at zero loads by using the Derjaguin-Müller-Toporov (DMT) contact model. The interlayer bonded bi-layer graphene shows a higher interfacial shear strength and contact radius than pristine bi-layer graphene. Lastly, we calculated the shear modulus and it was 10.33, 6.58, and 13.44 GPa for single-, bi-layer, and interlayer bonded bi-layer graphene. The interlayer bonded bi-layer graphene shows a higher shear modulus than pristine bi-layer graphene as expected from computer simulation/modelling papers.